Services Gateway - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
* It is not necessary to power off the device to remove/replace the NSPC and IOC; but
their removal causes disrupting of the routing functionality of the device. After the
replacement, you have to reboot the device for the new cards to be initialized.
Related
Documentation
Required Tools and Parts for Replacing Hardware Components on the SRX1400

Services Gateway

To replace hardware components, you need the tools and parts listed in Table 36 on
page 114.
Table 36: Tools and Parts Required for Replacing Hardware Components on the
SRX1400 Services Gateway
114
Required Tools and Parts for Replacing Hardware Components on the SRX1400
Services Gateway on page 114
SRX1400 Services Gateway Hardware Components on page 13
SRX1400 Services Gateway Front Panel on page 14
Overview of the SRX1400 Services Gateway Common Form-Factor Modules on page 11
Tool or Part
3/8-in. nut driver or pliers
Blank panels (if component is not reinstalled)
Electrostatic bag or antistatic mat
Electrostatic discharge (ESD) grounding wrist
strap
Flat-blade (–) screwdriver
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap
Components
Cables and connectors
DC power supply
IOC
NSPC
Power supply
SYSIOC
IOC
NSPC
SFP and XFP transceivers
Routing Engine
All
Cables and connectors
IOC
SYSIOC
I/O card
NSPC
Routing Engine
IOC
IOC
SYSIOC
Small form-factor pluggable (SFP) and SFP+ transceivers
Copyright © 2011, Juniper Networks, Inc.