Juniper SRX1400 Hardware Manual page 68

SRX1400 Services Gateway Hardware Guide
Related
Documentation
48
Remove the plastic handle inserts and lift the cardboard cover off the device.
3.
Remove the foam covering the top of the services gateway.
4.
Remove the accessory box and the SRX1400 Services Gateway Getting Started Guide.
5.
Figure 18: Unpack the SRX1400 Services Gateway
With a person on each side of the carton, carefully lift the device from the carton and
6.
place it on a flat, level surface. Remove the bag covering the device.
Verify the parts received against the list provided in the "Verifying Parts Received with
7.
the SRX1400 Services Gateway" on page 49.
Save the carton and the packing materials in case you need to move or ship the services
8.
gateway at a later time.
NOTE: The NSPC slot is covered with a filler cover, and the IOC slot is
covered with a blank panel at the time of shipment. Save the filler cover
and the blank panel after removing them from the slots, in case you need
them when you pack or move the chassis at a later time. The filler cover
does not have an overlay.
Proceed to install the services gateway.
9.
Installation Overview for the SRX1400 Services Gateway on page 51
Site Preparation Checklist for the SRX1400 Services Gateway on page 41
Required Tools and Parts for Unpacking the SRX1400 Services Gateway on page 47
Copyright © 2011, Juniper Networks, Inc.