Powering On The Srx1400 Services Gateway - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Related
Documentation

Powering On the SRX1400 Services Gateway

82
Secure each positive
Secure each negative
Replace the clear plastic cover over the terminal studs on the faceplate.
6.
Verify that the power cables are connected correctly, that they are not touching or
7.
blocking access to services gateway components, and it does not cause a tripping
hazard.
Repeat Steps 1 through 7 for the second power supply, if you are installing one.
8.
NOTE: If power is lost to the services gateway, the Power-On/Power-Off
state is retained. For example, if the services gateway loses power while the
device is on, when power returns, the device will still be in the On state.
Required Tools and Parts for Grounding and Providing Power to the SRX1400 Services
Gateway on page 77
Grounding the SRX1400 Services Gateway on page 78
Connecting the SRX1400 Services Gateway to an AC Power Supply on page 79
Powering On the SRX1400 Services Gateway on page 82
SRX1400 Services Gateway DC Power System Electrical Specifications on page 183
SRX1400 Services Gateway DC Power Supply Electrical Specifications on page 184
To power on the services gateway:
Ensure that you have connected the power supply to the device.
1.
Insert the plug into an AC power source receptacle (for AC-powered devices).
2.
Or
Attach the power cable to the DC power source (for DC-powered devices).
The device starts automatically as the power supply completes its startup sequence.
The Power LED blinks during startup and remains on steadily when the device is operating
normally.
DC source power cable lug to a
(+)
DC source power cable lug to a
(–)
(return) terminal.
RTN
(input) terminal.
-48V
Copyright © 2011, Juniper Networks, Inc.