Reinstalling Components Into The Srx1400 Services Gateway Chassis - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide

Reinstalling Components into the SRX1400 Services Gateway Chassis

Related
Documentation
62
To reinstall the components into the SRX1400 Services Gateway chassis:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see the SRX1400 Services Gateway Hardware Documentation
Identify the locations in the chassis where you will reinstall the removed components.
2.
Use the label you have marked on each removed component to identify the component
and its correct location in the chassis.
Slide each component into the chassis evenly so that it does not become stuck or
3.
damaged.
Tighten the latching levers or captive screws for each component as appropriate.
4.
NOTE: Do not expose the empty CFM (IOC and NSPC) slots in storage or
while transportation. Use appropriate covers (blank panel for IOC slot and
filler cover for NSPC slot) to prevent any dust or foreign objects from
damaging the electronics.
Required Tools for Installing the SRX1400 Services Gateway Manually on page 59
Removing Components from the Chassis for Manual Lifting of the SRX1400 Services
Gateway on page 59
Lifting the SRX1400 Services Gateway Chassis into a Rack on page 60
.
Copyright © 2011, Juniper Networks, Inc.