Juniper SRX1400 Hardware Manual page 81

Related
Documentation
Copyright © 2011, Juniper Networks, Inc.
Figure 23: Attach Mounting Hardware for Two-Post Rack
For front-mounting the chassis in a two-post rack, align the bottom hole in each
mounting bracket at the front edge of the chassis.
For rear-mounting the chassis in a two-post rack, align the bottom hole in each
mounting bracket at the rear edge of the chassis.
NOTE: Similarly, you can front-mount or rear-mount the chassis in a
four-post rack. However, there is no support shelf provided for the
unsupported edge of the chassis to rest.
Use the screws to attach the left and right brackets to the rack.
5.
Visually inspect the alignment of the chassis. If the chassis is installed properly in the
6.
rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side and the chassis should be level.
Required Tools for Installing the SRX1400 Services Gateway Manually on page 59
Removing Components from the Chassis for Manual Lifting of the SRX1400 Services
Gateway on page 59
Reinstalling Components into the SRX1400 Services Gateway Chassis on page 62
Chapter 5: Installing the SRX1400 Services Gateway
61