Connecting The Srx1400 Services Gateway To An Ac Power Supply - Juniper SRX1400 Hardware Manual

Connecting the SRX1400 Services Gateway to an AC Power Supply

Copyright © 2011, Juniper Networks, Inc.
Chapter 9: Grounding and Providing Power to the SRX1400 Services Gateway
WARNING: The device must be properly grounded before you connect the
AC power cords.
CAUTION: Do not mix AC and DC power supplies within the same services
gateway. Damage to the device might occur.
You connect AC power to the device by attaching power cords from the AC power sources
to the AC appliance inlets located on the power supplies.
To connect the AC power cords to the device for each power supply:
Locate the power cord or cords with the type of plug appropriate for your geographical
1.
location to connect the device to AC power.
For more information about model numbers, see the SRX1400 AC Power Cord
Specifications topic in the
Insert the appliance coupler end of the power cord into the appliance inlet on the
2.
power supply, as shown in Figure 31 on page 79.
Figure 31: Connect the Chassis to AC Power
Snap the wire bail on the power supply over the power cord to prevent the power cord
3.
from accidentally disengaging.
Insert the power cord plug into an external AC power source receptacle.
4.
NOTE: Each power supply must be connected to a dedicated AC power
feed and a dedicated external circuit breaker. We recommend that you
use a 15 A (250 VAC) minimum circuit breaker, or as permitted by local
code.
Dress the power cord appropriately.
5.
SRX1400 Services Gateway Hardware Documentation
.
79