Juniper SRX1400 Hardware Manual page 124

SRX1400 Services Gateway Hardware Guide
104
Table 33: LEDs on SRX1400 Services Gateway
LEDs Labels
Common One LED labeled
form-factor on the faceplate of
SERVICE
module following cards indicates the CFM's
(CFM) LED status:
NSPC
IOC
SYSIOC The following LEDs on the SYSIOC
LEDs faceplate indicate the status of the
card. If no LEDs are lit, the Routing
Engine may still be booting or the
SYSIOC is not receiving power.
ALARM (2 LEDs)
SIO
HA
PWR
FAN
NOTE: The LED labeled as
currently not supported in this release
and this LED always remains off.
Routing The following LEDs on the Routing
Engine LEDs Engine faceplate indicate the status
of the Routing Engine and hard disk
drive:
MASTER
HDD
STATUS (for the Routing Engine)
STATUS (for the Packet
Forwarding Engine controller)
OK/FAIL
Power One LED on each power supply
supply LEDs faceplate indicates the status of that
power supply.
For More Information
and SRX1400 Services Gateway Network
OK/FAIL
and Services Processing Cards on
page 22
16-Port Copper Ethernet/Fast
Ethernet/Gigabit Ethernet I/O Card on
page 28
16-Port SFP Gigabit Ethernet I/O Card
on page 29
2-Port XFP 10-Gigabit Ethernet I/O Card
on page 31
Troubleshooting with Chassis and
Interface Alarm Messages on the
SRX1400 Services Gateway on page 105
SRX1400 Services Gateway SYS I/O
Cards on page 16
Troubleshooting with Chassis and
Interface Alarm Messages on the
SRX1400 Services Gateway on page 105
AED is
SRX1400 Services Gateway Routing
Engine on page 24
Troubleshooting with Chassis and
Interface Alarm Messages on the
SRX1400 Services Gateway on page 105
SRX1400 Services Gateway AC Power
Supply on page 33
SRX1400 Services Gateway DC Power
Supply on page 35
Troubleshooting with Chassis and
Interface Alarm Messages on the
SRX1400 Services Gateway on page 105
Copyright © 2011, Juniper Networks, Inc.