Juniper SRX1400 Hardware Manual page 41

Copyright © 2011, Juniper Networks, Inc.
Table 14: System I/O Card LED Indicators (continued)
Label Color
(top) Green
PWR
Amber
Red
Unlit
NOTE: All SYSIOC status LEDs remain dark until Routing Engine initialization
is complete. The
complete, at which point the LED becomes solid green.
NOTE: The LED labeled as
Table 15 on page 21 describes the Ethernet port LEDs.
Table 15: SRX1400 Services Gateway Ethernet Port LEDs
LED Color State
Green On steadily
Link
Off
Green Blinking
ACT
Off
Chapter 2: SRX1400 Services Gateway Hardware Components
Status Indicated Behavior
Blinking The device is in one of two states:
Receiving power and is in the process of
booting up but has not yet initialized the
Routing Engine
Shutting down gracefully
On steadily The device is receiving power. The Power Good
signal for at least one power supply has been
received after Routing Engine initialization.
On steadily One of the power supplies has failed, but the
power available from the remaining power
supplies is sufficient to power all the installed
components.
On steadily One or more of the power supplies have failed,
and the power available from the remaining
power supplies is not sufficient to power all the
installed components.
Off The device is shut down.
PWR LED blinks green until Routing Engine initialization is
is currently not supported in this release.
AED
Description
Link is active.
Link is inactive.
Port is receiving or sending data.
Port might be on but is not receiving or
sending data.
21