Juniper SRX1400 Hardware Manual page 233

Appendix E: Using SRX3000 Series Services Gateway Hardware Components on SRX1400 Services Gateway
Related
Documentation
Copyright © 2011, Juniper Networks, Inc.
NOTE:
If a CFM slot is not occupied by a card, you must install a blank panel to
shield the empty slot and to allow cooling air to circulate properly through
the device.
The ONLINE button on SPC does not perform any function and currently
it is not supported.
Figure 66 on page 213 shows an SPC that can be used on an SRX1400 Services Gateway.
Figure 66: Services Processing Card
Table 54 on page 213 describes the SPC behavior indicated by the LEDs on its front panel.
Table 54: Services Processing Card LED Indicators
Label Color
Green
SERVICE
Amber
Red
Dark (unlit)
Green
OK/FAIL
Green
Red
Dark (unlit)
SRX3000 Series Services Gateway Cards Supported on SRX1400 Services Gateway
on page 209
SR X3K -SP
C-1 -10 -40
Status
On steadily
On steadily
On steadily
Off
On steadily
Blinking
On steadily
Off
Description
The SPC is running under
acceptable load.
The SPC is overloaded.
No service is being provided
by the SPC.
The SPC is not enabled.
The SPC is operating
normally.
The SPC is preparing for an
online insertion and removal
event.
The SPC has failed and is not
operating normally.
The SPC is powered down.
213