Connecting The Srx1400 Services Gateway To A Dc Power Supply - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Related
Documentation

Connecting the SRX1400 Services Gateway to a DC Power Supply

80
Verify that the power cord does not block the air exhaust or access to device
6.
components and does not cause a tripping hazard.
Repeat Steps 1 through 5 for the second power supply.
7.
If the LED indicates that the power supply is not functioning normally, repeat the
PWR
installation and cabling procedures.
NOTE: If power is lost to the services gateway, the Power-On/Power-Off
state is retained. For example, if the services gateway loses power while the
device is on, when power returns, the device will still be in the On state.
Required Tools and Parts for Grounding and Providing Power to the SRX1400 Services
Gateway on page 77
SRX1400 Services Gateway AC Power Supply on page 33
Grounding the SRX1400 Services Gateway on page 78
Connecting the SRX1400 Services Gateway to a DC Power Supply on page 80
Powering On the SRX1400 Services Gateway on page 82
SRX1400 Services Gateway AC Power System Electrical Specifications on page 188
SRX1400 Services Gateway AC Power Supply Electrical Specifications on page 188
CAUTION: Do not mix AC and DC power supplies within the same device.
Damage to the device might occur.
WARNING: The device must be properly grounded before you connect the
DC power cables.
Copyright © 2011, Juniper Networks, Inc.