Performing Initial Software Configuration On The Srx1400 Services; Gateway; Srx1400 Services Gateway Software Configuration Overview - Juniper SRX1400 Hardware Manual

CHAPTER 10
Performing Initial Software Configuration
on the SRX1400 Services Gateway

SRX1400 Services Gateway Software Configuration Overview

Copyright © 2011, Juniper Networks, Inc.
This chapter includes the following topics:
SRX1400 Services Gateway Software Configuration Overview on page 85
Performing Initial Software Configuration on the SRX1400 Services Gateway (CLI
Procedure) on page 86
The services gateway is shipped with Junos OS preinstalled and ready to be configured
when the device is powered on. You can configure the services gateway using the Junos
OS command-line interface (CLI), J-Web interface, SSH, or Telnet. However, you can
perform initial configuration using the CLI only.
The SRX1400 Services Gateway includes the copies of Junos OS in:
CompactFlash card in the Routing Engine
Hard disk in the Routing Engine
NOTE: You can also use the Junos OS stored in the USB flash drive inserted
into the Routing Engine faceplate.
When the device boots, the following sequence of events occurs:
The device attempts to start the image on the USB flash drive (if available).
1.
The device attempts to start the image from the CompactFlash card if the USB flash
2.
drive is not inserted into the Routing Engine or if the first attempt fails.
The device attempts to start the image from the hard disk if the first two methods
3.
fail.
You configure the services gateway by using Junos OS command-line interface (CLI)
commands, either on a console device attached to the
or over a Telnet connection to a network connected to the
SYSIOC.
CONSOLE port on the SYSIOC
port on the
RE ETHERNET
85