Juniper SRX1400 Hardware Manual page 241

Appendix E: Using SRX3000 Series Services Gateway Hardware Components on SRX1400 Services Gateway
Copyright © 2011, Juniper Networks, Inc.
To replace an SPC:
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis. For more information about ESD, see "Preventing
Electrostatic Discharge Damage to the SRX1400 Services Gateway" on page 149.
Loosen the captive screws at each end of the SPC faceplate.
3.
Grasp the SPC by its handle and slide it halfway out of the chassis.
4.
Figure 73: Removing an SPC from the SRX1400 Services Gateway
SRX 3K-S PC-1
-10- 40
Place one hand underneath the SPC to support it and slide it completely out of the
5.
chassis. See Figure 73 on page 221.
CAUTION: SPCs can become very warm during operation. Avoid contact
with the heat sink on top of the card when removing it to prevent personal
injury.
Place the SPC on the antistatic mat.
6.
Slide the replacement SPC into the slot until you feel resistance, and then press the
7.
SPC faceplate until it engages the connectors as shown in Figure 74 on page 222.
SRX 3K- NPC
221