Juniper SRX1400 Hardware Manual page 143

Copyright © 2011, Juniper Networks, Inc.
Chapter 13: Replacing Hardware Components on the SRX1400 Services Gateway
Pull open the ejector handles to unseat the NSPC. See Figure 39 on page 123.
4.
Figure 39: Removing an NSPC from the SRX1400 Services Gateway
Grasp the NSPC by the ejector handles and slide it halfway out of the chassis.
5.
Place one hand underneath the NSPC to support it and slide it completely out of the
6.
chassis.
CAUTION: The NSPC can become very warm during operation. Avoid
contact with the heat sink on top of the card when removing it to prevent
personal injury.
Place the NSPC on the antistatic mat.
7.
Slide the replacement NSPC into the slot until you feel resistance, and then press the
8.
NSPC's faceplate until it engages the connectors.
Tighten the captive screws on the left and right of the NSPC. See Figure 40 on page 123.
9.
Figure 40: Installing an NSPC in the SRX1400 Services Gateway
Power on the services gateway, as described in "Powering On the SRX1400 Services
10.
Gateway". The OK/FAIL
steadily.
LED on the NSPC faceplate should blink green, then light
123