2-Port Xfp 10-Gigabit Ethernet I/O Card - Juniper SRX1400 Hardware Manual

Related
Documentation

2-Port XFP 10-Gigabit Ethernet I/O Card

Copyright © 2011, Juniper Networks, Inc.
16-Port Copper Ethernet/Fast Ethernet/Gigabit Ethernet I/O Card on page 28
2-Port XFP 10-Gigabit Ethernet I/O Card on page 31
Installing an I/O Card with Copper Media Interfaces in an SRX1400 Services Gateway
on page 69
Installing an I/O Card with Fiber-Optic Media Interfaces in an SRX1400 Services
Gateway on page 70
Troubleshooting I/O Cards on the SRX1400 Services Gateway on page 107
The SRX3K-2XGE-XFP adds two ports for 10-gigabit Ethernet traffic from fiber interface
media. To use fiber interface media, install 10-gigabit small form-factor pluggable (XFP)
transceivers on the desired ports.
Figure 13 on page 31 shows the 2-Port XFP 10-Gigabit Ethernet IOC. Ports are numbered
from left to right, 0-1.
Figure 13: 2-Port XFP 10-Gigabit Ethernet I/O Card
NOTE:
If a CFM slot is not occupied by a card, you must install a blank panel to
shield the empty slot and to allow cooling air to circulate properly through
the device.
The ONLINE button on IOC does not perform any function and currently it
is not supported.
LEDs on the faceplate of the IOC indicate port status and connectivity. Table 23 on
page 32 describes the 2-Port XFP 10-Gigabit Ethernet IOC LEDs.
Chapter 2: SRX1400 Services Gateway Hardware Components
31