Services Processing Cards - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Related
Documentation

Services Processing Cards

212
Table 53: Network Processing Card LED Indicators
Label Color
Green
SERVICE
Amber
Dark (unlit)
Green
OK/FAIL
Red
Dark (unlit)
SRX3000 Series Services Gateway Cards Supported on SRX1400 Services Gateway
on page 209
Installing a Network Processing Card in an SRX1400 Services Gateway on page 214
Locating the Network Processing Card Serial Number Label on page 222
Replacing a Network Processing Card on the SRX1400 Services Gateway on page 219
Troubleshooting Network Processing Cards on the SRX1400 Services Gateway on
page 217
Services Processing Cards (SPCs) are common form-factor module (CFM) cards that
provide the processing power to run integrated services such as firewall, IP Security
(IPsec), and Intrusion Detection and Prevention (IDP). All traffic traversing the services
gateway is passed to an SPC to have services processing applied to it. Traffic is intelligently
distributed by Network Processing Cards (NPCs) to SPCs for services processing, including
session setup based on policies, fast packet processing for packets that match a session,
encryption and decryption, and Internet Key Exchange (IKE) negotiation.
Status Description
On steadily The NPC is mapped to an
IOC and is actively carrying
traffic.
On steadily The NPC is mapped to an
IOC, but there is no SPC
present or reachable in the
system so all traffic is
dropped.
Off The NPC is not carrying
traffic.
On steadily The NPC is operating
normally.
Blinking The NPC is preparing for a
an online insertion and
removal event.
On steadily The NPC has failed and is
not operating normally.
Off The NPC is powered down.
Copyright © 2011, Juniper Networks, Inc.