Gateway - Juniper SRX1400 Hardware Manual

Copyright © 2011, Juniper Networks, Inc.
Chapter 13: Replacing Hardware Components on the SRX1400 Services Gateway
The air filter is located in the rear of the chassis on the right side. The air filter weighs
approximately 0.2 lb (0.09 kg).
To replace the cooling system air filter:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis. For more information about ESD, see "Preventing
Electrostatic Discharge Damage to the SRX1400 Services Gateway" on page 149.
Turn the screw to the left on the fan tray door. Open it to the right and remove it. See
2.
Figure 35 on page 119
Figure 35: Removing the Cooling System Air Filter from the SRX1400
Services Gateway
Slide the air filter out of the chassis and properly dispose of it.
3.
Locate the up arrow on the replacement filter to ensure that the air filter is right side
4.
up.
Slide the air filter straight into the chassis until it stops as shown in Figure 36 on
5.
page 119.
Figure 36: Installing Cooling System Air Filter from the SRX1400 Services

Gateway

Replace the fan tray door and tighten the screw to secure it in the chassis.
6.
119