Gateway - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Related
Documentation
Troubleshooting Services Processing Cards on the SRX1400 Services Gateway
218
(%)
Slot State
3 Online
27
Use the CLI
show chassis fpc 3 detail
user@host> show chassis fpc 3 detail
Slot 3 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
seconds
Max Power Consumption
For further descriptions of the output from the commands, see the Junos System Basics
and Services Command Reference.
Network Processing Cards on page 211
Replacing a Network Processing Card on the SRX1400 Services Gateway on page 219
SRX3000 Series Services Gateway Cards Supported on SRX1400 Services Gateway
on page 209
To troubleshoot the an SPC, follow these guidelines:
Make sure the SPC is properly seated in the slot and its screws are tightened.
Make sure the double wide tray holder is installed properly in the slot.
Issue the CLI show chassis fpc 1
As shown in the sample output, the value
that the SPC is functioning normally:
user@host> show chassis fpc 1
(%)
Slot State
1 Online
27
Issue the CLI
show chassis fpc 1 detail
user@host> show chassis fpc 1 detail
Temp CPU Utilization (%)
(C) Total Interrupt
54 40 0
command for more detailed output.
Online
54 degrees C / 129 degrees F
1024 MB
0 MB
0 MB
2010-07-08 13:56:19 UTC
5 days, 20 hours, 34 minutes, 56
0 Watts
command n to check the status of installed SPC.
in the column labeled
Online
Temp CPU Utilization (%)
(C) Total Interrupt
34 40 0
command for more detailed output.
Copyright © 2011, Juniper Networks, Inc.
Memory Utilization
DRAM (MB) Heap Buffer
1024 3
indicates
State
Memory Utilization
DRAM (MB) Heap Buffer
1024 3