Juniper SRX1400 Hardware Manual page 111

Related
Documentation
Copyright © 2011, Juniper Networks, Inc.
Chapter 10: Performing Initial Software Configuration on the SRX1400 Services Gateway
}
}
}
[edit]
regress#
[edit]
Commit the configuration to activate it on the device.
18.
[edit]
admin@# commit
Optionally, configure additional properties by adding the necessary configuration
19.
statements. Then commit the changes to activate them on the device.
[edit]
admin@# commit
When you have finished configuring the device, exit configuration mode.
20.
[edit]
admin@# exit
admin@>
NOTE: To access the device using J-Web for the first time, enter the
configuration mode in the CLI, and set the management option using the
command
set system services web-management http
If you are using an interface other than
command
set security zones security-zone trust interface interface-name
host-inbound-traffic system-services http/https
Connecting the SRX1400 Services Gateway to a Network for Out-of-Band Management
on page 73
Connecting the SRX1400 Services Gateway to a Management Console or an Auxiliary
Device on page 74
SRX1400 Services Gateway Software Configuration Overview on page 85
.
, then you must also use the
fxp0
to set up J-Web.
91