Juniper SRX1400 Hardware Manual page 50

SRX1400 Services Gateway Hardware Guide
30
Figure 12 on page 30 shows the 16-Port SFP Gigabit Ethernet IOC. Ports are numbered
from top to bottom and left to right, 0-15.
Figure 12: 16-Port SFP Gigabit Ethernet I/O Card
NOTE:
If a CFM slot is not occupied by a card, you must install a blank panel to
shield the empty slot and to allow cooling air to circulate properly through
the device.
The ONLINE button on IOC does not perform any function and currently it
is not supported.
LEDs on the faceplate of the IOC indicate port status and connectivity. Table 22 on
page 30 describes the 16-Port SFP Gigabit Ethernet IOC LEDs.
Table 22: LED Indicators on the 16-Port SFP Gigabit Ethernet I/O Card
Label Color
SERVICE Green
Amber
Dark (unlit)
Green
OK/FAIL
Green
Red
Dark (unlit)
Status Indicated Behavior
On steadily The IOC is mapped to the Network and Service
Processing Card (NSPC) and is available to carry
Ethernet traffic.
On steadily The IOC is not mapped to the NSPC and is not
available to carry Ethernet traffic.
Off The IOC is administratively disabled but is mapped
to the NSPC.
On steadily The IOC is operating normally.
Blinking The IOC is preparing for an online insertion and
removal event:
Card is being Inserted: power up, booting,
initialization.
Card is being removed: shut down by chassis
management software.
On steadily The IOC has failed and is not operating normally.
Off The IOC is offline and can be safely removed.
Copyright © 2011, Juniper Networks, Inc.