Troubleshooting The Network And Services Processing Card On The Srx1400 Services Gateway - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Related
Documentation
Troubleshooting the Network and Services Processing Card on the SRX1400 Services
Gateway
108
Use the CLI
show chassis fpc
As shown in the sample output, the value
that the SYSIOC is functioning normally:
user@host> show chassis fpc 0
(%)
Slot State
0 Online
27
Use the CLI
show chassis fpc 0 detail
user@host> show chassis fpc 0 detail
Slot 0 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
seconds
Max Power Consumption
For further descriptions of the output from the commands, see the Junos System Basics
and Services Command Reference.
SRX1400 Services Gateway SYS I/O Cards on page 16
Replacing a System I/O Card on the SRX1400 Services Gateway on page 127
Juniper Networks Technical Assistance Center on page 105
To troubleshoot the Network and Services Processing Card (NSPC), follow these
guidelines:
Make sure the NSPC is properly seated in the slot and its screws are tightened.
Use the CLI
show chassis fpc 1
shown in the sample output for
labeled State indicates that the NSPC is functioning normally:
user@host> show chassis fpc 1
(%)
Slot State
command to check the status of the installed SYSIOC.
in the column labeled
Online
Temp CPU Utilization (%)
(C) Total Interrupt
41 40 0
command for more detailed output.
Online
41 degrees C / 105 degrees F
1024 MB
0 MB
0 MB
2010-07-08 13:56:19 UTC
5 days, 20 hours, 7 minutes, 49
0 Watts
command to check the status of installed NSPC. As
, the value
show chassis fpc 1
Temp CPU Utilization (%)
(C) Total Interrupt
Copyright © 2011, Juniper Networks, Inc.
indicates
State
Memory Utilization
DRAM (MB) Heap Buffer
1024 3
in the column
Online
Memory Utilization
DRAM (MB) Heap Buffer