Replacing A Services Processing Card On The Srx1400 Services Gateway - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Related
Documentation

Replacing a Services Processing Card on the SRX1400 Services Gateway

220
Place the NPC on the antistatic mat.
6.
Slide the replacement NPC into the slot until you feel resistance, and then press the
7.
NPC's faceplate until it engages the connectors as shown in Figure 72 on page 220.
Figure 72: Installing an NPC on the SRX1400 Services Gateway
SRX 3K- SPC
-1-1 0-40
Tighten the captive screws on the left and right of the NPC.
8.
WARNING: Never lift the services gateway using the handles on the front
panels of the NPCs or other CFM cards. The handles might come off,
causing the chassis to drop and inflicting possible grave injury.
When you power on the SRX1400 Services Gateway, the
faceplate blinks green, then lights steadily indicating a normal operating condition.
NOTE: If the
OK/FAIL
LED remains red, the NPC is not functioning properly. Contact your customer
support representative.
Required Tools and Parts for Replacing Hardware Components on the SRX1400
Services Gateway on page 114
Network Processing Cards on page 211
Troubleshooting Network Processing Cards on the SRX1400 Services Gateway on
page 217
SRX3000 Series Services Gateway Cards Supported on SRX1400 Services Gateway
on page 209
Field-Replaceable Units on the SRX1400 Services Gateway on page 113
SPCs are installed in the services gateway in slots labeled
SRX 3K- NPC
LED is red, remove and reinstall the NPC. If the
Copyright © 2011, Juniper Networks, Inc.
LED on the NPC
OK/FAIL
OK/FAIL
.
CFM1