Juniper SRX1400 Hardware Manual page 235

Appendix E: Using SRX3000 Series Services Gateway Hardware Components on SRX1400 Services Gateway
Related
Documentation
Copyright © 2011, Juniper Networks, Inc.
Figure 67: Installing Double Wide Tray Holder on SRX1400 Services
Gateway
Orient the NPC so that the faceplate faces you. Slide the NPC all the way into the card
5.
cage until you feel resistance. See Figure 68 on page 215
Figure 68: Installing an NPC on the SRX1400 Services Gateway
SRX 3K- SPC
-1-1 0-40
Tighten the screws on either side of the card.
6.
You can proceed with installing other hardware components, or power supplies, or
connecting to a management device. See "Powering On the SRX1400 Services Gateway"
on page 82 to power on the SRX1400 Services Gateway.
WARNING: Never lift the services gateway using the handles on the front
panels of the NPC or other CFM cards. The handles might come off, causing
the chassis to drop and inflicting possible grave injury.
SRX3000 Series Services Gateway Cards Supported on SRX1400 Services Gateway
on page 209
Network Processing Cards on page 211
Locating the Network Processing Card Serial Number Label on page 222
Replacing a Network Processing Card on the SRX1400 Services Gateway on page 219
SRX 3K- NPC
215