Juniper SRX1400 Hardware Manual page 146

SRX1400 Services Gateway Hardware Guide
126
Figure 42: Installing an IOC on the SRX1400 Services Gateway
If the IOC uses fiber-optic cable, remove the rubber safety cap from each transceiver
11.
and cable.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Insert the appropriate cables into the cable connector ports on each IOC.
12.
CAUTION: Do not let fiber-optic cable hang free from the connector. Do
not allow fastened loops of cable to dangle, which stresses the cable at
the fastening point.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Power on the services gateway, as described in "Powering On the SRX1400 Services
13.
Gateway" on page 82. The
light steadily.
NOTE: If the
LED remains red, the IOC is not functioning properly. Contact your
OK/FAIL
customer support representative.
WARNING: Never lift the services gateway using the handles on the front
panels of the IOCs or other CFM cards. The handles might come off, causing
the chassis to drop and inflicting possible grave injury.
LED on the IOC faceplate should blink green, then
OK/FAIL
LED is red, remove and reinstall the IOC. If the
OK/FAIL
Copyright © 2011, Juniper Networks, Inc.