Installing A Dc Power Supply In The Srx1400 Services Gateway - Juniper SRX1400 Hardware Manual

Installing a DC Power Supply in the SRX1400 Services Gateway

Related
Documentation
Copyright © 2011, Juniper Networks, Inc.
Chapter 6: Installing Additional Components into the SRX1400 Services Gateway
To install a DC power supply:
Ensure that the voltage across the DC power source cable leads is 0 V and that there
1.
is no chance that the cable leads might become active during installation.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis. For more information about ESD, see "Preventing
Electrostatic Discharge Damage to the SRX1400 Services Gateway" on page 149.
Orient the power supply so that the locking lever is on the left, as shown in Figure 27
3.
on page 67.
Figure 27: Installing a DC Power Supply in the SRX1400 Services Gateway
Using both hands, slide the power supply straight into the chassis until the power
4.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplate.
Proceed with connecting the power supply to DC power. See "Connecting the SRX1400
5.
Services Gateway to a DC Power Supply" on page 80.
SRX1400 Services Gateway Power Supplies Overview on page 32
SRX1400 Services Gateway DC Power Supply on page 35
Installing an AC Power Supply in the SRX1400 Services Gateway on page 66
Connecting the SRX1400 Services Gateway to a DC Power Supply on page 80
67