Juniper SRX1400 Hardware Manual page 141

1
1
Copyright © 2011, Juniper Networks, Inc.
Chapter 13: Replacing Hardware Components on the SRX1400 Services Gateway
Figure 37: Removing the Routing Engine from the SRX1400 Services
Gateway
2
Captive screws
1.
Ejector handles
2.
Grasp the Routing Engine by the ejector handles and slide it halfway out of the chassis.
6.
Place one hand underneath the Routing Engine to support it and slide it completely
7.
out of the chassis.
Place the Routing Engine on the antistatic mat.
8.
Carefully align the sides of the replacement Routing Engine with the guides inside the
9.
chassis.
Slide the Routing Engine into the slot until you feel resistance, and then press the
10.
Routing Engine faceplate until it engages the connectors.
Press both of the ejector handles inward to seat the Routing Engine. See Figure 38 on
11.
page 121
Figure 38: Installing the Routing Engine on the SRX1400 Services Gateway
2
Tighten the captive screws on the left and right of the Routing Engine.
12.
Reconnect cables previously attached to the AUX or USB ports.
13.
Power on the services gateway by pressing the Power button on the front panel of
14.
the SYSIOC for three to five seconds if the Routing Engine does not start automatically.
Wait for the device to start. The
blink green, then light steadily.
LED on the Routing Engine faceplate should
OK/FAIL
121