Installing An I/O Card With Fiber-Optic Media Interfaces In An Srx1400 Services Gateway - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Related
Documentation

Installing an I/O Card with Fiber-Optic Media Interfaces in an SRX1400 Services Gateway

70
Orient the IOC so that the faceplate faces you. Slide the IOC all the way into the card
4.
cage until you feel resistance.
Tighten the screws on either side of the card.
5.
Insert the appropriate cables into the cable connector ports on each IOC. Secure the
6.
cables so that they are not supporting their own weight. Place excess cable out of the
way in a neatly coiled loop. Placing fasteners on a loop helps to maintain its shape.
You can proceed with installing other hardware components, or power supplies, or
connecting to a management device. See "Powering On the SRX1400 Services Gateway"
on page 82 to power on the SRX1400 Services Gateway.
WARNING: Never lift the services gateway using the handles on the front
panels of the IOCs or other CFM cards. The handles might come off, causing
the chassis to drop and inflicting possible grave injury.
16-Port Copper Ethernet/Fast Ethernet/Gigabit Ethernet I/O Card on page 28
Installing an I/O Card with Fiber-Optic Media Interfaces in an SRX1400 Services
Gateway on page 70
SRX1400 Services Gateway Hardware Components on page 13
Before installing your card, see "SRX1400 Services Gateway Front Panel" on page 14 to
verify that you have selected an appropriate slot location.
To install an IOC that supports fiber-optic media interfaces:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
For more information about ESD, see "Preventing Electrostatic Discharge Damage to
the SRX1400 Services Gateway" on page 149.
Place the IOC on an antistatic mat or remove it from its electrostatic bag.
2.
Identify the slot on the services gateway where you will install the IOC.
3.
Copyright © 2011, Juniper Networks, Inc.