Installing An Ac Power Supply In The Srx1400 Services Gateway - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide

Installing an AC Power Supply in the SRX1400 Services Gateway

Related
Documentation
66
Installing a DC Power Supply in the SRX1400 Services Gateway on page 67
To install an AC power supply:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
For more information about ESD, see "Preventing Electrostatic Discharge Damage to
the SRX1400 Services Gateway" on page 149.
Orient the power supply so that the locking lever is on the left, as shown in Figure 26
2.
on page 66.
Figure 26: Installing an AC Power Supply in the SRX1400 Services Gateway
Using both hands, slide the power supply straight into the chassis until the power
3.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplate or blank installed in the power supply slot.
Proceed with connecting the power supply to AC power. See "Connecting the SRX1400
4.
Services Gateway to an AC Power Supply" on page 79 for information on connecting
the power supply to AC power.
SRX1400 Services Gateway Power Supplies Overview on page 32
SRX1400 Services Gateway AC Power Supply on page 33
Installing a DC Power Supply in the SRX1400 Services Gateway on page 67
Connecting the SRX1400 Services Gateway to an AC Power Supply on page 79
Copyright © 2011, Juniper Networks, Inc.