Troubleshooting I/O Cards On The Srx1400 Services Gateway; Troubleshooting The System I/O Card On The Srx1400 Services Gateway - Juniper SRX1400 Hardware Manual

Troubleshooting I/O Cards on the SRX1400 Services Gateway

Related
Documentation

Troubleshooting the System I/O Card on the SRX1400 Services Gateway

Copyright © 2011, Juniper Networks, Inc.
To troubleshoot an IOC, follow these guidelines:
Make sure the IOC is properly seated in the slot and its screws are tightened.
Issue the CLI
show chassis fpc 2
shown in the sample output, the value
that the IOC is functioning normally:
user@host> show chassis fpc 2
(%)
Slot State
2 Online
27
Issue the CLI show chassis fpc 2 detail
user@host> show chassis fpc 2 detail
Slot 2 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
seconds
Max Power Consumption
For further descriptions of the output from the commands, see the Junos System Basics
and Services Command Reference.
16-Port Copper Ethernet/Fast Ethernet/Gigabit Ethernet I/O Card on page 28
16-Port SFP Gigabit Ethernet I/O Card on page 29
2-Port XFP 10-Gigabit Ethernet I/O Card on page 31
Replacing an I/O Card on the SRX1400 Services Gateway on page 124
Juniper Networks Technical Assistance Center on page 105
To troubleshoot a SYSIOC , follow these guidelines:
Make sure the SYSIOC is properly seated in the slot and its screws are tightened.
Chapter 12: Troubleshooting the SRX1400 Services Gateway
command to check the status of installed IOCs. As
Online in the column labeled
Temp CPU Utilization (%)
(C) Total Interrupt
32 39 0
command for more detailed output.
Online
32 degrees C / 89 degrees F
1024 MB
0 MB
0 MB
2010-07-08 13:56:19 UTC
5 days, 19 hours, 59 minutes, 31
0 Watts
State indicates
Memory Utilization
DRAM (MB) Heap Buffer
1024 3
107