Juniper SRX1400 Hardware Manual page 122

SRX1400 Services Gateway Hardware Guide
102
Use the CLI
show chassis fpc
shown in the sample output, the value
that the card is functioning normally:
user@host> show chassis fpc
(%)
(%)
Slot State
0 Online
27
1 Online
27
2 Online
27
3 Online
27
Using a question mark (?) gives you a listing of the various options for the command
as shown below:
user@host> show chassis fpc ?
Possible completions:
<[Enter]>
<fpc-slot>
detail
pic-status
|
To view information about a particular card in the chassis, use the
user@host> show chassis fpc 3
(%)
Slot State
3 Online
27
For more detailed output, add the
a slot number, which is optional:
user@host> show chassis fpc detail
regress@host-pubs> show chassis fpc detail
Slot 0 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
Total DDR DRAM
Start time:
Uptime:
Max Power Consumption
Slot 1 information:
command to check the status of the installed cards. As
in the column labeled
Online
Temp CPU Utilization (%)
Temp CPU Utilization (%)
(C) Total Interrupt
42 40 0
34 40 0
32 40 0
55 40 0
Execute this command
FPC slot number (0..3)
Display detailed output
Show Physical Interface Cards installed in FPC
Pipe through a command
Temp CPU Utilization (%)
(C) Total Interrupt
54 39 0
detail option. The following example does not specify
Online
42 degrees C / 107 degrees F
1024 MB
0 MB
0 MB
2010-07-08 13:56:19 UTC
2 hours, 23 minutes
0 Watts
Copyright © 2011, Juniper Networks, Inc.
indicates
State
Memory Utilization
Memory Utilization
DRAM (MB) Heap Buffer
1024 3
1024 3
1024 3
1024 3
slot option:
fpc
Memory Utilization
DRAM (MB) Heap Buffer
1024 3