Srx1400 Services Gateway Laser And Led Safety Guidelines And Warnings; General Laser Safety Guidelines - Juniper SRX1400 Hardware Manual

Related
Documentation

SRX1400 Services Gateway Laser and LED Safety Guidelines and Warnings

General Laser Safety Guidelines

Copyright © 2011, Juniper Networks, Inc.
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
Chassis Lifting Guidelines on page 151
Installation Instructions Warning on page 152
SRX1400 Services Gateway General Safety Guidelines and Warnings on page 145
Rack-Mounting Requirements and Warnings on page 153
This topic includes the following sections:
General Laser Safety Guidelines on page 157
Class 1 Laser Product Warning on page 158
Class 1 LED Product Warning on page 158
Laser Beam Warning on page 159
Radiation from Open Port Apertures Warning on page 160
When working around the services gateway, observe the following safety guidelines to
prevent eye injury:
Do not look into unterminated ports or at fibers that connect to unknown sources.
Do not examine unterminated optical ports with optical instruments.
Avoid direct exposure to the beam.
WARNING: Unterminated optical connectors can emit invisible laser
radiation. The lens in the human eye focuses all the laser power on the
retina, so focusing the eye directly on a laser source—even a low-power
laser—could permanently damage the eye.
Appendix A: Safety and Regulatory Compliance Information
157