Juniper SRX1400 Hardware Manual page 91

Copyright © 2011, Juniper Networks, Inc.
See "SRX1400 Services Gateway Front Panel" on page 14 for details about where the
individual modules can be installed.
Orient the IOC so that the faceplate faces you. Slide the IOC all the way into the card
4.
cage until you feel resistance.
Tighten the screws on either side of the card.
5.
Install XFP or SFP transceivers as appropriate into the sockets on the IOC:
6.
NOTE: We strongly recommend the use of Juniper Networks SFP and XFP
transceivers. We cannot guarantee correct operation if other transceivers
are used. The transceiver type can be different in each port, as long as a
Juniper Networks-support transceiver part number is used.
Take each new transceiver to be installed out of its electrostatic bag and identify
a.
the port on the IOC where it will be installed.
Verify that each transceiver is covered with a rubber safety cap. Cover any
b.
transceivers without a safety cap.
Remove the rubber dust covers from each SFP or XFP socket in which you will
c.
install a transceiver.
Carefully align the transceiver with the sockets in the IOC. The connectors should
d.
face the IOC.
Slide the transceiver until the connector is seated in the IOC slot. If you are unable
e.
to fully insert the transceiver, make sure the connector is facing the right way.
Close the ejector handle of the transceiver.
f.
Remove the rubber safety cap from each transceiver and cable.
7.
Chapter 7: Installing I/O Cards on the SRX1400 Services Gateway
71