Locating The Network Processing Card Serial Number Label - Juniper SRX1400 Hardware Manual

SRX1400 Services Gateway Hardware Guide
Related
Documentation

Locating the Network Processing Card Serial Number Label

222
Figure 74: Installing an SPC on the SRX1400 Services Gateway
SRX 3K-S PC-1
-10- 40
Tighten the captive screws on the left and right of the SPC.
8.
When you power on the SRX1400 Services Gateway, the
faceplate blinks green, then lights steadily indicating a normal operating condition.
NOTE: If the OK/FAIL
LED remains red, the SPC is not functioning properly. Contact your customer
support representative.
WARNING: Never lift the services gateway using the handles on the front
panels of the SPCs or other CFM cards. The handles might come off, causing
the chassis to drop and inflicting possible grave injury.
Required Tools and Parts for Replacing Hardware Components on the SRX1400
Services Gateway on page 114
Services Processing Cards on page 212
Troubleshooting Services Processing Cards on the SRX1400 Services Gateway on
page 218
Field-Replaceable Units on the SRX1400 Services Gateway on page 113
The serial number label for the NPC is located on the center left side of the card (see
Figure 75 on page 223).
SRX 3K- NPC
OK/FAIL
LED is red, remove and reinstall the SPC. If the
Copyright © 2011, Juniper Networks, Inc.
LED on the SPC
OK/FAIL