Juniper SRX1400 Hardware Manual page 237

Appendix E: Using SRX3000 Series Services Gateway Hardware Components on SRX1400 Services Gateway
Related
Documentation
Troubleshooting Network Processing Cards on the SRX1400 Services Gateway
Copyright © 2011, Juniper Networks, Inc.
Figure 70: Installing an SPC on the SRX1400 Services Gateway
SRX 3K-S PC-1
-10- 40
Tighten the screws on either side of the card.
6.
You can proceed with installing other hardware components or power supplies, or
connecting to a management device. See "Powering On the SRX1400 Services Gateway"
on page 82 to power on the SRX1400 Services Gateway.
WARNING: Never lift the services gateway using the handles on the front
panels of the SPC or other CFM cards. The handles might come off, causing
the chassis to drop and inflicting possible grave injury.
SRX3000 Series Services Gateway Cards Supported on SRX1400 Services Gateway
on page 209
Services Processing Cards on page 212
Troubleshooting Services Processing Cards on the SRX1400 Services Gateway on
page 218
Replacing a Services Processing Card on the SRX1400 Services Gateway on page 220
Locating the Services Processing Card Serial Number Label on page 223
To troubleshoot an NPC, follow these guidelines:
Make sure the NPC is properly seated in the slot and its screws are tightened.
Make sure that the double wide tray holder is properly installed in the slot.
Use the CLI
show chassis fpc 3
installed NPC.
As shown in the sample output, the value
that the NPC is functioning normally:
user@host> show chassis fpc 3
SRX 3K- NPC
command with the slot number to check the status of
in the column labeled
Online
indicates
State
217