Installing I/O Cards On The Srx1400 Services Gateway; Installing A Copper Or Fiber I/O Card In An Srx1400 Services Gateway; Installing An I/O Card With Copper Media Interfaces In An Srx1400 Services Gateway - Juniper SRX1400 Hardware Manual

CHAPTER 7
Installing I/O Cards on the SRX1400
Services Gateway

Installing a Copper or Fiber I/O Card in an SRX1400 Services Gateway

Installing an I/O Card with Copper Media Interfaces in an SRX1400 Services Gateway

Copyright © 2011, Juniper Networks, Inc.
This chapter includes the following topic:
Installing a Copper or Fiber I/O Card in an SRX1400 Services Gateway on page 69
This following topics describe installation procedures for two types of I/O cards that the
services gateway supports:
Installing an I/O Card with Copper Media Interfaces in an SRX1400 Services
Gateway on page 69
Installing an I/O Card with Fiber-Optic Media Interfaces in an SRX1400 Services
Gateway on page 70
Before installing your card, see "SRX1400 Services Gateway Front Panel" on page 14 to
verify that you have selected an appropriate slot location.
To install an IOC that supports copper media interfaces:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
For more information about ESD, see "Preventing Electrostatic Discharge Damage to
the SRX1400 Services Gateway" on page 149.
Place the IOC on an antistatic mat or remove it from its electrostatic bag.
2.
Identify the slot on the services gateway where it will be installed.
3.
See "SRX1400 Services Gateway Front Panel" on page 14 for details about where the
individual modules can be installed.
69