Powering On The Srx340 Services Gateway; Powering Off The Srx340 Services Gateway - Juniper SRX340 Hardware Manual

Powering On the SRX340 Services Gateway

To power on the services gateway:
1. Insert the power cord plug into an AC power source receptacle.
2. Turn on the power to the AC power receptacle.
The device starts automatically as the power supply completes its startup sequence. The PWR LED lights
during startup and remains on when the device is operating normally.
NOTE: After the power supply is turned on, it can take up to 60 seconds for status
indicators—such as the STAT and PWR LEDs—to show that the power supply is functioning
normally. Ignore error indicators that appear during the first 60 seconds.
NOTE: When the system is completely powered off and you turn on the power supply, the
device starts as the power supply completes its startup sequence. If the device finishes starting
and you need to power off the system again, first issue the CLI request system power-off
command.

Powering Off the SRX340 Services Gateway

You can power off the services gateway in one of the following ways:
Graceful shutdown—Press and immediately release the Power button. The device begins gracefully
shutting down the operating system and then powers itself off.
CAUTION:
gateway.
Forced shutdown—Press the Power button and hold it for ten seconds. The device immediately powers
itself off without shutting down the operating system.
Use the graceful shutdown method to power off or reboot the services
52