Powering On The Srx110 Services Gateway; Powering Off The Srx110 Services Gateway - Juniper SRX110 Manual

Powering On the SRX110 Services Gateway

Related
Documentation

Powering Off the SRX110 Services Gateway

Copyright © 2012, Juniper Networks, Inc.
Chapter 14: Connecting, Grounding, and Powering On the SRX110 Services Gateway
To power on the services gateway:
Ensure that you have connected the power supply to the device.
1.
Insert the plug of the power supply adapter into an AC power source receptacle.
2.
Turn on the power to the services gateway.
3.
The device starts automatically as the power supply completes its startup sequence.
The Power LED lights up during startup and remains on steadily when the device is
operating normally.
NOTE: After the power supply is turned on, it can take up to 60 seconds for
status indicators—such as the Status and Power LEDs—to show that the
power supply is functioning normally.
NOTE: We recommend you issue the CLI command
when you want to power off the device immediately after powering it on.
Powering Off the SRX110 Services Gateway on page 105
Resetting the SRX110 Services Gateway on page 107
Connecting the SRX110 Services Gateway to the Power Supply on page 101
Grounding the SRX110 Services Gateway on page 103
Using the Reset Config Button on the SRX110 Services Gateway on page 145
SRX110 Services Gateway Front Panel and Back Panel Views with 3G and Integrated
VDSL2 on page 9
SRX110 Services Gateway LEDs on page 13
You can power off the services gateway in one of two ways:
Graceful shutdown — Press and release the Power button. The device begins gracefully
shutting down the operating system and then powers itself off.
Forced shutdown — Press the Power button and hold it for more than 10 seconds. The
device immediately powers itself off without shutting down the operating system.
NOTE: Do not press the Power button while the device is shutting down.
request system power-off
105