Table of Contents
Advertisement
Mutoh Ultima Multi-Purpose Cutting Plotter - Operation Instructions
2.8. LOADING MEDIA
When loading media into the cutter, it is necessary to clearly distinguish two situations. The first situation is
when you are using cut-sheet media. The second situation is when you are using roll media.
2.8.1. Loading cut sheet media
Step 1 :
Put the pressure rollers in the "up" position using the media hold lever and turn the power switch
ON.
The cutter will perform its initialization routine and move the tool head to the rightmost position.
Step 2 :
Press the media-select button on the operation panel and select the sheet. After selection the
SHEET-LED will light up.
Step 3 :
Insert the media into the cutter. It is best to position the media so that half of it hangs in front and
half of it hangs at the back of the cutter.
Step 4 :
Adjust the position of the pressure rollers so that they align well with the drive rollers. Doing this
you are helped by the tactile and audible click system for the left pressure roller. The right
pressure roller's movement is limited so that it can never be malpositioned.
Always make sure that the pressure rollers are completely inside the sheet of the media you want
to load. Especially when you use a cut-sheet of which the corners are not perfectly square, it is
best to put the pressure rollers well inside the vinyl as the width of the sheet may vary.
In case you are using a SC-1400D, you have the opportunity to use either two or three pressure
rollers, depending on the width of the vinyl you are using. When not using the left pressure roller
(i.e. when loading vinyl of a small width), the left pressure roller should be placed at the extreme
left of the cutter (that is, not on top of a grid roller).
Notes :
Please note that the middle pressure roller should always be placed on top of a grid
roller.
19
AP-75125, Rev 1.3 ; 20/10/04
Hide quick links:
Advertisement
Table of Contents
