Chapter 3
Note
Please be aware that this chapter is for Kona only.
3.1
EasySIGN
3.1.1
Update EasySIGN
Please be sure to always have the latest service pack of EasySIGN installed on your
computer.
Refer to
Compatibility overview on page 9
compatible with the Kona / Kona apparel and CutServer.
There is a special driver update required when working with the Kona / Kona apparel series
cutters. This file ( Mutoh.drv ) can be found on
existing Mutoh.drv.
3.1.2
EasySIGN driver installation
When installing the cutter, you might need to install the driver twice. Once for the CutServer
and once for direct cutting (com port).
Once via the CutServer (to be used with the auto-align barcode workflow) and once via the
virtual com port (created by the Kona / Kona apparel USB driver) for normal sign cutting jobs.
Start EasySIGN.
Step 1:
AP-75381 - Revision 1.3
Setting up your
print and cut
software
to know which versions of EasySIGN are
Mutoh's FTP
Application Guide Kona / Kona apparel
Setting up your print and cut software
and should be copied over the
3
37