The Tool Carriage Does Not Move Up/Down; Some Unexpected Lines Are Plotted; The Cutting Force Is Not Applied Correctly - MUTOH ValueCut VC2-1800 Maintenance Manual

The tool carriage does not move up/down.

[Check item]

Is the blade holder installed properly?

Is the flat cable damaged?

Is the carriage board damaged?

Is the carriage damaged?

Is the encoder of carriage damaged?

Is the driver damaged?

Is the linear bearing shaft of carriage rusty?

Some unexpected lines are plotted.

[Check item]

Is the blade holder installed properly?

Is the media warp? Or are there some bubbles? Re-load the media or replace if needed.

Is the vacuum fan working?

Does the tool carriage move up/down?

Is the output command HPGL or HPGL/2?

Are there some communication errors?

The cutting force is not applied correctly.

[Check item]

Is the cutting force set properly?

Is the blade length out of the holder too short?

Does the cutter holder move smoothly?

Is there any problem on the holder encoder?
VC2E-MM-00
[Action]
Refer to user's guide and reinstall the holder.
Replace the flat cable.
Replace the carriage board.
Replace the carriage set.
Replace the carriage set.
Replace the main board.
Replace the carriage set.
[Action]
Refer to user's guide and reinstall it.
Replace the fan or main board.
Please refer to the previous item.
Ask your software agent for help.
Check the communication protocol.
[Action]
Reset the cutting force on panel or with command.
Re-load the blade and readjust.
Change the carriage set.
Change the carriage set.
58
MAINTENANCE MANUAL