Displaying Modulation Profiles - ADC CUDA 3 Administration Manual

Displaying Modulation Profiles

Cuda 12000 IP Access Switch CLI-based Administration Guide
cli# modulation-profile 3 interval-usage short diff
cli# modulation-profile 3 interval-usage short seed
cli# modulation-profile 3 interval-usage short pre-len 8
cli# modulation-profile 3 interval-usage short last-cw fixed
cli# modulation-profile 3 interval-usage long fec-tbytes 6
cli# modulation-profile 3 interval-usage long fec-len 8
cli# modulation-profile 3 interval-usage long burst-len 120
cli# modulation-profile 3 interval-usage long mod qpsk
cli# modulation-profile 3 interval-usage long no scrambler
cli# modulation-profile 3 interval-usage long diff
cli# modulation-profile 3 interval-usage long seed
cli# modulation-profile 3 interval-usage long pre-len 8
cli# modulation-profile 3 interval-usage long last-cw fixed
You can then verify the new modulation profile using the show cable
interface <c/s/i> modulation-profile <profile number> command from
within either root or cable interface mode, or the show modulation-profile
<profile number> command from within cable interface mode.
You display the modulation profiles currently configured on a cable interface
by performing one of following tasks:
.
Task
1. Enter this command within root
mode or cable interface
configuration mode to display all
modulation profiles on the
specified cable interface.
2. Enter this command within cable
interface configuration mode to
display all modulation profiles on
the specified cable interface.
Defining Modulation Profiles
Command
show interface cable <c/s/i>
modulation-profile
show modulation-profile
425
38
38