ADC CUDA 3 Administration Manual page 133

Cuda 12000 IP Access Switch CLI-based Administration Guide
Packet Scrambling
Enables scrambling of SONET Synchronous Payload Envelopes (SPEs) on this
interface. Note that both end-points of the transmission must use the same
scrambling. Scrambling is disabled by default.
To configure scrambling on a POS interface, perform the following task in
interface pos <c/s/i> mode:
Task
Enable scrambling on the POS
interface.
Note the following:
Only normal Path Remote Defect Indication is currently supported on
POS interfaces.
Only SONET signal (framing) is supported on POS interfaces. Configuring
and Viewing SONET Alarms
Packet Over SONET (POS) Interface Administration
Command
pos scramble
131