Configuring The Power Assertion Level - ADC CUDA 3 Administration Manual

Configuring the Power Assertion Level

Cuda 12000 IP Access Switch CLI-based Administration Guide
You must verify the assertion level specified by the power supply vendor to
indicate fault conditions, and set the assertion levels as specified by the
vendor.
To configure the assertion level that the power supply utilizes when
indicating a fault condition, perform the following tasks:
Task
1. Enter root mode.
2. Set the assertion level to report
AC current faults.
3. Set the assertion level to report
DC current faults.
4. Set the assertion level to report
power supply temperature
faults.
To display the assertion levels currently configured for both AC and DC and
power supply temperature fault indications, perform the following tasks:
Task
1. Enter root mode.
2. Display the assertion level
currently configured for the
reporting of AC current faults.
3. Display the assertion level
currently configured for the
reporting of DC current faults.
4. Display the assertion level
currently configured for the
reporting of power supply
temperature faults.
Assertion Levels
Command
root
aux-device ac-monitor fault-level
{active-high | active-low}
aux-device dc-monitor fault-level
{active-high | active-low}
aux-device ps-temp fault-level
{active-high | active-low}
Command
root
show aux-device ac-monitor
show aux-device dc-monitor
show aux-device ps-temp
151