ADC CUDA 3 Administration Manual page 296

294 C 14: C
HAPTER ONFIGURING
IP
Task
9. Configure the interface to
advertise only the default route.
When RIP is enabled for the first
time on the interface, the interface
does not advertise default routes.
10.Configure the interface to
advertise the default route in
addition to other routes. When RIP
is enabled for the first time on the
interface, the interface does not
advertise default routes.
11.Enter the cost or metric that is to
be used for the default route entry
in RIP updates originated on this
interface. A value of zero indicates
that no default route should be
originated; in this case, a default
route via another router may be
propagated. When RIP is enabled
for the first time on the interface,
the default cost is 0.
12.Configure the interface to
implement split horizon. When RIP
is enabled for the first time on the
interface, split horizon is enabled.
13.Configure the interface to
implement poisoned reverse.
When RIP is enabled for the first
time on the interface, poisoned
reverse is enabled.
14.Configure the IP addresses of RIP
neighbors. Note that, because RIP
can automatically learn the IP
addresses of neighbors, you may
configure a RIP neighbor that the
Cuda 12000 has learned
automatically. In this case, the
static neighbor entry you create
takes precedence over the
dynamically created entry.
Command
ip rip send default-only
ip rip send default-also
ip rip default cost <number>
Note: Before you can specify a default
cost, you must issue the ip rip send
default-only or ip rip send
default-also commands.
ip rip split-horizon
ip rip poisoned-reverse
ip rip neighbor <ip-address>
ADC Telecommunications, Inc.