ADC CUDA 3 Administration Manual page 260

258 C 12: C
HAPTER ONFIGURING
Task
1. Modify the default DHCP policy.
Note that you do not define
matching criteria for the default
policy. You simply configure it to
permit forwarding to up to 32
DHCP servers, or drop the packet.
2. Modify the default BOOTP policy.
Note that you do not define
matching criteria for the default
policy. You simply configure it to
permit forwarding to BOOTP
servers, or drop the message.
Task
1. Display the default DHCP policy.
2. Display the default BOOTP policy.
DHCP R
ELAY
Configuring Default Policies
To modify the default DHCP or BOOTP policy used on all interfaces of a
specific DOCSIS module, enter interface cable <c/s/i> mode for one of the
interfaces on the selected DOCSIS module and perform the following task:
To display the currently configured default DHCP or BOOTP policy, enter
interface cable <c/s/i> mode for one of the interfaces on the selected
DOCSIS module and perform the following tasks:
Note that you cannot delete the default DHCP or BOOTP policy.
Command
dhcp-policy default
{permit <ip-address>... | deny}
bootp-policy default
{permit <ip-address>... | deny}
Command
show dhcp-policy default
show bootp-policy default
ADC Telecommunications, Inc.