Physical Interface Mode - ADC CUDA 3 Administration Manual

46 C 2: A
HAPTER BOUT THE

Physical Interface Mode

C L I
OMMAND INE NTERFACE
Physical interface mode allows for the administration of a specified interface,
including interface-specific configuration and information displays. To enter
this mode, you must specify the chassis/slot/port-number (c/s/i) combination
that identifies the physical interface that you want to configure. After you
enter this mode, all configuration that you perform pertains to the interface
that you specified.
To enter interface configuration mode, type interface <c/s/i> from within
any configuration mode. The CLI automatically displays the type of interface
for the specific c/s/i. The following tables list interface commands by type:
Table 2-3 — Lists available DOCSIS interface mode commands as they
appear when you type help at the command prompt.
Table 2-4 — Lists available Ethernet interface mode commands as they
appear when you type help at the command prompt.
Table 2-5 — Lists available POS interface mode commands as they appear
when you type help at the command prompt.
Keep in mind that the help command output displays many commands in
their abbreviated form. Also keep in mind that global commands are not
listed in any of these tables and can be found in Table 2-1 on page 42.
NOTE: The commands displayed via help , ? , and through the double Tab
action are relevant to the selected interface.
Table 2-3 DOCSIS Interface Mode Commands
Command
access-class
access-list
admission-control
analyzer
arp
bootp-policy
cable
Description
Applies an access list to the current interface.
Creates an access list, which consists of IP filtering
rules.
Enables and disables admission control.
Enables the protocol analyzer.
Sets the ARP timeout parameter.
Defines BOOTP request policies.
Optional prefix to commands in this mode.
ADC Telecommunications, Inc.