Creating Bridge Groups - ADC CUDA 3 Administration Manual

Creating Bridge Groups

Task
Create a bridge group.
Task
1. Display a specified bridge group.
2. Display all bridge groups within
the system.
Cuda 12000 IP Access Switch CLI-based Administration Guide
You must first create a network-layer bridge group before you can configure
it. After you create the bridge group, you then configure it within interface
configuration mode.
You can identify bridge groups using either numbers or strings; the text
string that you specify is case-sensitive. To create a network-layer bridge,
perform the following task within any mode:
The following example creates a network-layer bridge called Bridge_1, then
uses the show bridge-group command to verify its creation:
cli:172.16.19.10:root# bridge-group Bridge_1
cli:172.16.19.10:root# show bridge-group
Bridge Group: Bridge_1
cli:172.16.19.10:root#
To display network-layer bridges, perform the following tasks within any
mode:
Creating Bridge Groups
Command
bridge-group <string>
Command
show bridge-group <bridge-group>
show bridge-group
347