Disabling And Enabling Interfaces - ADC CUDA 3 Administration Manual

Disabling and Enabling Interfaces

Cuda 12000 IP Access Switch CLI-based Administration Guide
Display Element
Loopback
Last clearing of counters
PPP Authentication Security Mode
Clearing Interface Counters
You can clear interface counters for a selected POS interface. To do so,
perform the following task within interface pos <c/s/i> mode:
Task
Clear all counters for the current POS
interface.
You can manually take an interface offline or bring it online. When an
interface is enabled (online), it can forward traffic; when disabled (offline) it
cannot.
NOTE: Enabling a POS interface assumes the POS interface is already
configured.
To disable and enable a POS interface, perform the following tasks in
interface pos <c/s/i> mode:
Task
1. Disable the POS interface so that
the administrative status is down.
2. Enable the POS interface so that the
administrative status is up.
In this example, the user disables the POS interface in slot 3 and then brings
it back online:
cli:172.16.19.10:root# interface 1/3/1
mode: interface:pos:csi(1/3/1)
cli:172.16.19.10:interface:pos:csi(1/3/1)# shutdown
cli:172.16.19.10:interface:pos:csi(1/3/1)# no shutdown
Packet Over SONET (POS) Interface Administration
Description
Indicates loopback configuration.
Time (SysUpTime) since the counters were
last cleared and reset to zero.
Indicates authentication used on this
interface — PAP or CHAP
Command
clear counters
Command
shutdown
no shutdown
123