ADC CUDA 3 Administration Manual page 510

508 C 20: S
HAPTER UBSCRIBER
M
ANAGEMENT
Parameter
SID
To modify default Subscriber Management filter groups, perform the
following tasks.
Use the show modem command to determine the IP address, MAC
address and service ID (SID):
Use the show cm-filter command to determine the group id.
Task
1. Enter interface mode.
2. Modify a default filter group
for a CPE device for
downstream traffic.
3. Modify a default filter group
for a CPE device for upstream
traffic.
4. Modify a default filter group
for a cable modem for
downstream traffic.
5. Modify a global filter group
for a cable modem for
upstream traffic.
Description
A session identifier that detects whether the
packet refers to a cable modem or CPE device.
For upstream packets, the SID is identified in
the "parm2" field of the packet structure.
For downstream packets, an ARP lookup is
performed to determine for which cable
modem the packet is destined.
Command
interface:cable:csi <c/s/i>
cm modify cpe-downstream <group id>
{<ip address> | <mac address> | <sid>}
cm modify cpe-upstream <group id>
{<ip address> | <mac address> | <sid>}
cm modify cm-downstream <group id>
{<ip address> | <mac address> | <sid>}
cm modify cm-upstream <group id>
{<ip address> | <mac address> | <sid>}
ADC Telecommunications, Inc.