ADC CUDA 3 Administration Manual page 415

Cuda 12000 IP Access Switch CLI-based Administration Guide
To configure frequency hopping on an upstream channel, perform the
following tasks in interface:cable:csi <c/s/i> mode:
Task
1. Setup a policy for an upstream
channel.
2. Set the upstream burst profile
number.
3. Set the percentage error
threshold.
4. Set the threshold interval, in
seconds.
5. Set the center frequency value,
in MHz
Example
The following example configures Policy Number 1 on Upstream Channel 1:
cli:192.168.208.3:interface:cable:csi(1/1/1)# spectrum-group 1
upstream 1 profile 1 threshold 1 interval 10 frequency 5.0
cli:192.168.208.3:interface:cable:csi(1/1/1)#
Display Policy Number 1 on all Upstream Channels
You display all Policy Number 1's on all upstream channels by performing the
following tasks:
Task
1. Enter interface cable mode.
2. Display the frequency hopping
policy on an upstream channel.
Configuring Frequency Hopping
Command
spectrum-group <1...5> upstream
<port number>
spectrum-group <rule number>
upstream <port number> profile
<upstream modulation number>
{0...255}
spectrum-group <rule number>
upstream <port number> profile
<upstream modulation number>
{0...255} threshold {1...100}
spectrum-group <rule number>
upstream <port number> profile
<upstream modulation number>
{0...255} threshold {1...100}
interval {10...86400}
spectrum-group <rule number>
upstream <port number> profile
<upstream modulation number>
{0...255} threshold {1...100} interval
{10...86400} frequency {5.0...42.0}
Command
interface cable <c/s/i>
show spectrum-group <rule number>
upstream
413