Displaying Igmp Groups And Interface Parameters - ADC CUDA 3 Administration Manual

358 C 17: M
HAPTER ANAGING

Displaying IGMP Groups and Interface Parameters

IP M
ULTICAST
Use the following procedure to configure IGMP interface parameters:
Task
1. Enter configuration mode for the
selected interface.
2. Set the IGMP interface parameter. ip igmp {query-interval <seconds> |
You can display IGMP groups and interface parameters from either root
mode or configuration mode.
Displaying Groups and Parameters from Root Mode
Use this procedure to display IGMP groups and interface parameters from
root mode:
Task
1. Enter root mode.
2. Display groups or interface
parameters.
Note that:
When you issue the show ip igmp groups command without specifying
a group address or an interface, the command displays all groups on all
interfaces.
When you issue the show ip igmp interface command without
specifying an interface, the command displays details on all interfaces.
Command
interface <c/s/i>
query-max-response time <seconds>
| version {2 | 1 | v2_only} |
robustness <value> | router |
last-query-interval <seconds>}
Command
root.
show ip igmp
{groups {<group-address> | <c/s/i>} |
interface <c/s/i>}
ADC Telecommunications, Inc.